Prepare Rails
Insert Carriage Stopper
Insert Carriage
Insert Gearbar
Insert Pulley Posts
6
5
4
3
2
1
9
Assembling the Reformer
STOP! Read these instructions completely before beginning or refer to our online assembly video at: merrithew.com/eq-assembly
ASSEMBLY & SET-UP
1.
Wipe rails [14] and inner c-channels [51], with a damp
cloth to remove dust and dirt. Insert carriage stopper [47]
in one of six positions.
CAUTION:
The carriage stopper must be FULLY inserted into
one of the six positions AT ALL TIMES. Never use oil lubricants
as they may damage rollers.
NOTE:
SPX MAX MODELS ARE SHIPPED WITH THE CARRIAGE INSTALLED.
4. V2 MAX & REHAB V2 MAX:
Align fixed rollers [37] with
c-channels [51], then adjust floating rollers [38] as necessary
before guiding carriage [15] into rails [14]. Engage at least one
spring into the gearbar [8] after installation.
CAUTION:
We strongly advise that two people perform
the carriage replacement to prevent damaging rollers.
NOTE:
SPX MAX models are shipped with the carriage installed.
5A. SPX MAX:
Insert pulley posts [27] fully into receptacles
[23] at back of Reformer and tighten star knobs [36]. Ensure
eyehooks [52] on top of pulley posts are parallel to rails [14].
3. TRADITIONAL MODELS:
Insert gearbar [8] into the middle
gearbar slots with the concave indentations [inset above] facing
the Wooden Standing Platform [1].
5B. V2 MAX & REHAB V2 MAX:
Pull the plunger button [50] on
the back of the receptacles [23], slide to the preferred height and
lock into place in one of the pre-drilled holes.
NOTE:
V2 Max Reformers have 6 pre-drilled holes.
Rehab V2 Max Reformers have 12 pre-drilled holes.
2.
To determine correct length of ropes [24], set carriage stopper
[47] in the second position. Attach springs to gearbar [8]
to ensure carriage [15] does not move.
