13
2. MAX PLUS FRAMES:
To use traveling pulleys [58]
extend ropes and detach double-ended swivel spring clips [19]
and Soft Reformer Loops [18]. Pinch end loop of ropes and
insert through the bottom of traveling pulleys [58]. Reattach
double-ended spring clips [19] and Soft Reformer Loops [18]
and reset rope to desired length.
1.
Remove the receptacle covers and slide vertical frame into
receptacles [71]. For Max Plus models, position pulley system
facing carriage. For traditional models, position highest eyehooks
facing carriage. Tighten all four hex bolts [72]. Attach springs,
roll-down bar and safety chain as illustrated.
See page 7
[fig. Traditional vertical frame].
CAUTION:
We strongly advise that two people perform this step
to ensure the frame bars are level and fit evenly and securely into
the receptacle to allow for proper alignment.
3.
To alter the height of traveling pulleys [58], pull out spring-
loaded stoppers [68]. Shift the traveling pulleys up or down
vertical sliding tracks [60] and release spring-loaded stoppers
[68]. Shake pulleys to confirm they are fully locked into stopper
positions [70].
Remove all springs from vertical frame, including roll-down bar
[62] and safety chain [57]. Loosen all four hex bolts [72] at the
base of receptacles [71]. Secure push-thru bar [64] in place by
hand while removing vertical frame.
NOTE:
Requires two people.
4.
For exercises using arm [73] or leg springs [69], attach
springs to traveling spring hooks [65], and adjust height
in the same way as traveling pulleys [58]. After changing
position, shake spring hooks to confirm they are fully
locked into stopper positions [70].
Installing the Vertical Frame
Consult our online assembly video at
merrithew.com/eq-assembly
Removing the Vertical Frame
