MERLO PANORAMIC, Руководство пользователя и по обслуживанию

Страница: 93 / 200

5 - OPERATING INSTRUCTIONS
5 - 5
If stabilisers are to be used (if the machine is equipped with front stabilisers),.
follow these instructions:
-
correctly stabilise the machine as described in the relevant paragraph of this
manual remember that to stabilise the machine the telescopic boom must not
pass beyond the upper edge of the cab. if this is not the case, it will be
impossible to stabilise the machine (Fig. X)
- check that the machine is perfectly levelled using the spirit level in the cab
If intending to operate on tyres follow these instructions:
-
level the machine using the crossways tilt corrector; remember that to level
the machine the telescopic boom must not pass beyond the upper edge of the
cab. if this is not the case, it will be impossible to use the crossways tilt
corrector (TILTING) (Fig.Y)
- prior to start any movement, set both speed range and direction selectors in
their neutral position "N".
WARNING! Manoeuvring loads suspended on cables, chains, slings
or other is prohibited if the machine is not equipped with the Merlo attachment specific to such use (hook on forks,
hook on carriage, crane boom, fly jib etc...)
When using compatible and type-approved Merlo attachments, always refer to the relevant load chart present in the
holder provided in the cab.
If operations with the platform must be carried out near overhead electricity cables, the person in charge must ask
whoever manages the cables and the area's health and safety authorities for the minimum safety distance from the
cables, so that all necessary precautions for avoiding accident risks can be taken.
-
bring the forks into a horizontal position and approach the load with care, lifting and extending the telescopic boom the
minimum possible or, if necessary, slowly advancing the machine (Fig.8)
- position the forks under the load taking care that they insert easily (Fig.9)
- shift the gear selector switch (19) and direction switch (20) into position "N"
- lift the load a few centimetres and tilt the carriage upwards (Fig.10)
- if possible, slowly and carefully reverse the machine then lower and retract the telescopic boom to bring the load into the
transportation position (Fig.11)
- in the transport position, move the machine into the area where the load is to be placed
- lift and extend the telescopic boom until the load is above the stack; if necessary advance the machine with care. (Fig.12)
- shift the gear selector switch (19) and direction switch (20) into position "N"
- bring the forks into a horizontal position and correctly place the load on top of the stack, lowering and retracting the
telescopic boom (Fig.13). Reverse the machine in order to retract the forks