MERLO P25.6, Инструкция по эксплуатации, Страница: 88 / 232

6 - ORDINARY MAINTENANCE
6 - 10
- COVER 6
Inside COVER 6, which is placed behind the driver's cab, there are the return filter and the filling cap of the hydraulic system.
To remove COVER 6, use a proper spanner to unscrew the 3 screws shown in the picture.
- COVER 7
Inside COVER 7, which is placed behind the driver's seat, there is the electrical box where the fuses, the relays and the
electronic boards of the machine can be found.
Proceed as follows to open COVER 7:
• unscrew fixing screws "V"
• remove COVER 7
Proceed as follows to close COVER 7:
• rest COVER 7 on the two lower supports of the electrical box
• tighten fixing screws "V"
- COVER 8
Inside COVER 8, which is placed in the rear part of the machine, there are both the hydrostatic motor and the oil filling/oil level
check plug of the rear differential.
To open COVER 8, unscrew 4 fixing screws "A".
NOMENCLATURE - ENGINE COMPARTMENT
Pay particular attention to the position of the engine
compartment
components mentioned in this
paragraph, as they will be referred to and described
in the paragraphs devoted to MAINTENANCE.
NOMENCLATURE
1) Diesel engine
2) Hydrostatic transmission oil level cup
3) Engine coolant level cup
4) Engine air intake filter
5) Engine air intake pipe
6) Hydrostatic transmission oil filter
7) Hydrostatic pump
8) Diesel oil filter
9) Engine oil dipstick
10) Engine oil filler cap
11) Oil/ water radiator
12) Battery
13) Manual battery cut-off switch