MERLO P25.6, Инструкция по эксплуатации, Страница: 49 / 232

4 - CONTROLS AND INSTRUMENTS
4 - 19
6) WEIGHING MODIFICATION (G)
Should you need to either modify or delete one or several weighings stored in
table 'B' you can do that using the modification function available on the
WEIGHING SCREEN. Scroll the weighing screen with button (P2) until you
select 'EDIT DATA', then press button (P3) to confirm. Now the manual weighing
symbol and an eraser appear under buttons (P4) and (P5) respectively.
To select the weighing to be modified press button (P2) until this is highlighted in
a flashing mode, then press either button (P4) to repeat a manual weighing or
button (P5) to delete the weighing (Fig. 5). Press button (P3) to confirm your
selection.
Press button (P1) to go back to the main screen.
• SWITCH FOR THE SELECTION OF THE TYPE OF ATTACHMENT
INSTALLED ON THE CARRIAGE
Your machine is equipped with a 4-position selector switch (204) which allows
the operator to select -either manually or automatically- the type of attachment
installed on the carriage, so as to determine the load capacity chart suitable for
the machine/attachment combination.
The 4 positions of switch (204) for the selection of the type of attachment
installed are the following (Fig. 1):
a) AUTO: self-identification of the attachment installed on the carriage
b) 0.5/0.6: attachments where the centre of gravity of the load being lifted is 0.5 /
0.6 metres away from the carriage
c) 1.5: attachments where the centre of gravity of the load being lifted is 1.5
metres away from the carriage
d) 4: attachments where the centre of gravity of the load being lifted is 4 metres
away from the carriage
The graphic representation of selector (204) is also shown on display (D) in the
cab, in field (222) (Fig. 2), and it is displayed when:
- no attachment is installed on the carriage.
- no attachment is identified on the carriage.
- an error/a failure occurs in the attachment self-identification system
When an attachment is installed and identified on the carriage and the system
works correctly, the graphic representation of selector (204) in field (220)
changes over to the symbol of the attachment installed (see below in this
paragraph)
For the operation modes of selector (204) please refer to the following instructions: