MERLO P25.6, Инструкция по эксплуатации, Страница: 110 / 232

6 - ORDINARY MAINTENANCE
6 - 32
The system total capacity is 6,2 litres.
CLEANING OF THE RADITOR CORE
Should you need, clean the radiating mass using a jet of water at a maximum pressure of 30 bar or using compressed air and
directing the jet in the directio of arrow "3"
Should it be necessary to clean the inside of compartment "B" due to any material settled there, carry out the following
operations:
- lift locking device "L"
- release bracket "S" from the retainer
- lift the straw protection, and clean compartment "B"
To close the straw protection grid again, carry out the following operations:
- lower the straw protection grid
- couple bracket "S" to the retainer on the chassis
- lower locking device "B"
Before starting your machine, check that the straw protection grid is correctly in place.
• ENGINE OIL
Periodically check the engine oil as follows:
-
Place the machine on a flat ground and switch off the diesel engine
- Wait a few minutes so that the engine cools off and let the engine oil flow into
the oil sump
- Check the oil level by extracting stick "A"; the level must be above the
"miniumum" notch
WARNING! If the oil level is below the "minimum" notch, do not
start the diesel engine.
Do not fill the engine oil tank above the "maximum" level.
To obtain more accurate information, it is recommended to check the oil
level before starting your working day and when the engine is cold.
For all other information on the use and maintenance of the diesel engine,
refer to the related manual.
If needed, unscrew filling cap "B" and fill up with the engine oil indicated in
paragraph
"OIL TABLE" in chapter "STICKERS WITH CONTROL
DESCRIPTIONS - LEAFLETS IN THE CABIN".