Meridian Fuel Express, Руководство оператора

Страница: 52 / 96

11-2
October 2014 | Revision 1.0 Meridian Manufacturing, Inc.
11.2 WHEEL BEARINGS
Each axle is equipped with a grease zerk under
the center dust cap of the wheel. Add grease
sparingly to the wheel bearings, using only wheel
bearing grease. The wheel bearings should be
repacked annually. Check for excessive end play
and tighten, if necessary.
IMPORTANT
Over-greasing wheel bearings can cause them to
overheat, resulting in damage and/or failure.
CAUTION
Do not raise the trailer off the ground
with fuel in the tank. Always make sure
the tank is empty before performing any
maintenance.
11.3 BATTERY
Inspect the battery at least once every six
months and before using the Fuel Trailer at the
beginning of the season. Always follow the safety
instructions when servicing a battery.
11.3.1 Battery Safety
1.
Keep all sparks and flames away from
batteries, as gas given off by electrolyte
is explosive.
2. Avoid contact with battery electrolyte:
wash off any spilled electrolyte
immediately because battery acid can
cause severe chemical burns.
3. Wear safety glasses when working
near batteries.
4. Do not tip batteries more than 45 degrees, to
avoid electrolyte loss.
5. To avoid injury from a spark or short
circuit, disconnect the battery ground
cable before servicing any part of the
electrical system. Never short circuit
the battery; it may explode.
6. Protect battery terminals, battery-
charger terminals, and cables against
accidental contact, which can cause
sparks, explosions, or component
damage.
7.
Never attempt to jump-start a frozen battery.
11.3.2
Battery Replacement and
Maintenance Tips
• Check the batteries at least every six months for
low voltage, leakage, etc.
• Always use the correct size and type of battery.
Replace old batteries with a new 12 Volt deep
cycle battery.
• Do not install the battery cable to the wrong
terminal. Make sure the RED cable is connected
to the + (plus) terminal and the BLACK cable is
connected to the – (minus) terminal.
• Remove the batteries from the fuel trailer if not
expected to be in use for several months.
• Use recommended practices when recharging a
dead battery.
• Remove any corrosion from the battery posts
using a wire brush terminal cleaner. Corrosion
can also be removed using a baking soda paste
and water to neutralize and remove the acid
from the battery terminals.
• Dispose of old batteries properly.
Chapter 11 | Maintenance