Mercury Axius System, Руководство пользователя

Страница: 26 / 60

Section 2 - On the Water
Page 22 CMD-4082082 / 90-8M0052072
eng
FEBRUARY 2011
The RPM display of VesselView also shows an orange icon under the RPM numbers if the engines exceed a 10% difference in
RPM of each other, and the icon turns red when they synchronize.
To disengage Sync mode:
1. Place the ERC levers in any detent.
2. Press the "SYNC" button.
To re‑engage Sync mode, press the "SYNC" button.
Helm Transfer—Standard Stations
Helm Transfer
Some boats are designed to allow control of the vessel from more than one location. These locations are commonly referred to
as helms or stations. Helm transfer is a term used to describe the method of transferring control from one helm (or station) to
another helm.
!
WARNING
Avoid serious injury or death from loss of boat control. The boat operator should never leave the active station while engine is
in gear. Helm transfer should only be attempted while both stations are manned. One‑person helm transfer should only be
performed while engine is in neutral.
The helm transfer function allows the boat operator to select which helm is in control of the vessel. Before a transfer can be initiated
the ERC levers at the active helm and at the helm intended for the transfer must be in the neutral position.
NOTE: If you attempt to transfer helm control when the ERC levers are not in neutral, a beep will sound and the helm transfer will
not succeed until the levers at the helms are moved to neutral and transfer is requested again.
Some fault codes may appear on VesselView if other control or navigation functions are attempted after the helm transfer
procedure is started. To remove the fault codes it may be necessary to cycle the key switch off and on, and then restart the helm
transfer procedure. Ensure that other control and navigation inputs are performed after helm transfer is complete to avoid setting
fault codes.
NOTICE
The ERC levers must be in neutral to perform a helm transfer. While in neutral your vessel could drift and collide with objects
nearby resulting in damage. Keep an adequate look out while performing the helm transfer.
To avoid damage, use extra care when attempting a helm transfer while the vessel is close to docks, piers, or other fixed items
or when near other vessels.
Requesting Helm Transfer
NOTE: Any movement of the joystick or ERC levers after pressing the "TRANSFER" button terminates the helm transfer request.
A single beep sounds and the transfer button light turns off signaling the end of the transfer request.
To request the transfer of vessel control from one helm to another:
1. At the helm you are requesting be made active and with the ERC levers in neutral, press the "TRANSFER" button one time.
After the "TRANSFER" button is pressed, the transfer button light turns on and one beep will sound confirming the impending
transfer.
SYNC
1 LEVER
NEUTRAL
TROLL
THROTTLE
ONLY
DOCK
TRANSFER
+
-
22593
"TRANSFER" button
NOTE: If the ERC levers at the helms are not in neutral, the neutral lights will flash. Move all the ERC levers to neutral and
the neutral light should then be on.
2. With the "TRANSFER" button light and neutral light on, press the "TRANSFER" button a second time to complete the helm
transfer.
3. When the helm transfer is complete, another beep sounds and the transfer button light turns off.