Mercedes-Benz Sprinter, Руководство по эксплуатации

Страница: 270 / 354

#
Using the lug wrench from the vehicle tool kit,
unscrew the now visible bolts counter-clock-
wise by approximately 20 turns.
#
Slightly raise spare wheel carrier 4 and
unhook left-hand retaining hook
3
.
#
Assemble the pump lever for the jack and slide
it into sleeve 5 on the right-hand side of
spare wheel carrier 4 .
#
Raise the spare wheel carrier with the pump
lever and unhook right-hand retaining hook 3 .
#
Prepare the jack.
#
Place the jack beneath the corresponding jack
support point.
#
Move the pump lever up and down until the tire
is raised a maximum of 1.18 in (3 cm) off the
ground.
#
Carefully remove the spare wheel from spare
wheel carrier 4 . The spare wheel is heavy.
When the spare wheel is removed, the center
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
#
Install the spare wheel on the vehicle.
#
Lower the vehicle.
Vehicles with rear wheel drive: installing the spare
wheel (vehicle with lowered chassis)
%
In the event of a flat tire, you may store the
defective wheel inside the vehicle only. An
intact wheel may be stored in the spare wheel
carrier only when the vehicle is unladen. A
laden vehicle must first be raised.
#
Carefully place the spare wheel onto spare
wheel carrier 4 . The spare wheel is heavy.
When you place the spare wheel onto spare
wheel carrier 4 , the center of gravity changes
due to the weight of the wheel. The spare
wheel may slip down or tip over.
#
Slide the pump lever for the jack into sleeve
5
on spare wheel carrier
4
.
#
Raise spare wheel carrier 4 with the pump
lever and attach right-hand retaining hook 3 .
#
Slightly raise spare wheel carrier 4 and
attach left-hand retaining hook 3 .
#
Pull the pump lever out of sleeve 5 .
#
Using the lug wrench, tighten safety hook bolts
3 by turning them clockwise.
#
Replace and engage covers
1
.
#
Close the rear-end doors.
Vehicles with rear wheel drive: removing the spare
wheel (chassis)
#
Loosen wing nuts 3 manually and then
remove them.
#
Loosen nuts 2 as far as the thread end.
#
Slightly raise spare wheel carrier 4 and
unhook left-hand retaining hook 1 .
#
Assemble the pump lever for the jack and slide
it into sleeve on the right-hand side of spare
wheel carrier 4 .
#
Raise spare wheel carrier 4 with the pump
lever and unhook right-hand retaining hook 1 .
#
Slowly lower spare wheel carrier 4 to the
ground.
#
Lift spare wheel carrier 4 slightly and pull the
pump lever out of the sleeve.
#
Use the pump lever to lift the spare wheel
beyond the rear edge of the spare wheel car-
rier.
#
Carefully remove the spare wheel from the
spare wheel carrier. The spare wheel is heavy.
When the spare wheel is removed, the center
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
Vehicles with rear wheel drive: installing the spare
wheel (chassis)
#
Carefully place the spare wheel onto spare
wheel carrier
4
. The spare wheel is heavy.
When you place the spare wheel onto the
spare wheel carrier, the center of gravity
changes due to the weight of the wheel. The
spare wheel may slip down or tip over.
268 Wheels and tires