Mercedes-Benz Sprinter, Руководство по эксплуатации

Страница: 133 / 354

#
To lower automatically: briefly press the lower
section of switch 2 .
Electronic level control automatically lowers
the vehicle to the next lower position:
R
From the highest position to driving level
R
From driving level to the lowest position
%
By pressing button
1
during the movement,
the original position will be reset.
#
To raise automatically: briefly press the lower
section of switch 1 .
Electronic level control automatically raises the
vehicle to the next higher position:
R
From the lowest position to driving level
R
From driving level to the highest position
%
By pressing button 2 during the movement,
the original position will be reset.
#
To switch on automatic mode: drive at over
6.2 mph (10 km/h) or release the parking
brake.
Electronic level control controls the vehicle
level automatically.
Using electronic level control for charging with air
in an emergency
* NOTE Damage due to excess pressure
If the pressure in the air suspension bellows is
too high, the compressed-air lines or the air
suspension bellows can be damaged.
#
In doing so, do not exceed the maximum
permissible operating pressure of
0.113 ksi (900 kPa (9 bar/130 psi)).
Only for vehicles with valves for electronic level
control emergency charging: if electronic level
control is malfunctioning and the vehicle is leaning,
you can raise or lower the vehicle by connecting
an external compressed-air source to one of the
emergency valves (similarly to tire valve). If elec-
tronic level control is not operational, you can
drive on carefully to the nearest qualified specialist
workshop and have the malfunction remedied.
#
Apply the parking brake.
#
Vehicles with automatic transmission: shift the
transmission to position
j
.
#
Switch off the vehicle.
#
Turn the valve cap of the corresponding valve
( 1 L = left, 2 R = right).
#
Stand to the side of the vehicle when connect-
ing the external compressed-air source.
#
Raise or lower the vehicle level by charging or
releasing compressed air until the driving level
has been reached and the vehicle is in a hori-
zontal position. While doing so, ensure you
observe the maximum permissible operating
pressure of 900 kPa (9 bar/130 psi).
#
Disconnect the external compressed-air
source.
#
Tighten the valve cap on the valve ( 1 L = left,
2
R = right).
#
Drive on carefully to the nearest qualified spe-
cialist workshop.
Rectifying problems with the electronic level con-
trol
You cannot raise or lower the vehicle level when
stationary
Possible cause:
R
The compressor is in danger of overheating.
After repeatedly raising and lowering the vehi-
cle, electronic level control play protection is
deactivated.
#
Try to set the vehicle level manually again after
approximately one minute.
or
Driving and parking 131