Seat belts
85
1
Belt sash guide
2
Belt tongue
3
Buckle
4
Release button
Routing the belt
X
Adjust the seat and move the backrest to
an almost vertical position (
Y
page 74).
X
Pull the belt smoothly through belt sash
guide
1
.
X
Route the belt over the centre of the shoul-
der without twisting it.
X
Engage belt tongue
2
into buckle
3
.
X
If necessary, pull upwards on the shoulder
section of the belt to tighten the belt across
your body.
Routing the belt
X
Press release button
4
and guide belt
tongue
2
back towards belt sash guide
1
.
Belt warning for driver and front
passenger
The
<
seat belt warning lamp in the instru-
ment cluster reminds you that all occupants
should fasten their seat belts. The
<
seat
belt warning lamp may light up continuously
or it may flash. Additionally, there may be a
warning tone.
The
<
seat belt warning lamp goes out and
the warning tone ceases when the driver and
the front passenger have fastened their seat
belt.
For certain countries only: regardless of
whether the driver or the front passenger is
already secured, the
<
seat belt warning
lamp lights up for six seconds after the engine
has been started. The
<
seat belt warning
lamp then goes out if both the driver and the
front passenger have fastened their seat belt.
i
Further information about the
<
seat
belt warning lamp (
Y
page 233).
Controls
230_AKB; 5; 4, en-GB
bjanott,
Version: 2.9.6
2008-04-08T15:09:54+02:00 - Seite 85
Z
Dateiname: 6515_3089_02_buchblock.pdf;
preflight