Flat tyre
268
X
Screw air pump hose
6
onto flange
7
of
TIREFIT filler bottle
1
.
X
Place TIREFIT sealant filler bottle
1
head
downwards into recess
3
of the electric
air pump.
8
Filler hose
9
Valve
X
Remove the cap from valve
9
on the faulty
tyre.
a
Pressure release screw
b
Pressure gauge
X
Make sure pressure release screw
a
on
pressure gauge
b
is fully closed.
X
Screw filler hose
8
onto valve
9
.
X
Insert plug
5
into the socket of the ciga-
rette lighter* (
Y
page 166) or into a 12V
power socket in your vehicle
(
Y
page 166).
X
Turn the key to position 2 (
Y
page 73) in
the ignition lock.
X
Press on/off switch
4
on the electric air
pump to I.
The electric air pump is switched on. The
tyre is inflated.
i
First, TIREFIT is pumped into the tyre. The
pressure can briefly rise to around 5 bar.
Do not switch off the electric pump dur-
ing this phase.
X
Let the electric pump run for five minutes.
The tyre should then have a pressure of at
least 1.8 bar.
!
Do not operate the electric air pump for
longer than six minutes without a break.
Otherwise, it may overheat.
The air pump can be operated again once
it has cooled down.
If a pressure of 1.8 bar is not reached after
five minutes:
X
Switch off and disconnect the electric air
pump and drive the vehicle forwards or
backwards approximately 10 m.
This distributes the TIREFIT more evenly.
X
Remove TIREFIT sealant filler bottle
1
from the electric pump.
X
Pump up the tyre again.
Practical advice
* optional
230_AKB; 5; 4, en-GB
bjanott,
Version: 2.9.6
2008-04-08T15:09:54+02:00 - Seite 268
Dateiname: 6515_3089_02_buchblock.pdf;
preflight
