Mercedes-Benz GLC 200 4MATIC, Руководство пользователя

Страница: 437 / 601

* NOTE Damage to the wheels' plastic ele-
ments when changing a wheel
Plastic elements on wheels may be damaged
when removing and repositioning the wheel.
#
Do not raise the wheels by the plastic
elements when removing and reposition-
ing.
#
Slide the wheel to be mounted onto the cen-
tring pin and push it on.
&
WARNING Risk of injury from tightening
wheel bolts and nuts
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip.
#
Only tighten wheel bolts or wheel nuts
when the vehicle is on the ground.
#
Be sure to observe the instructions and safety
notes on "Changing a wheel" (
/
page 426).
#
For safety reasons, only use wheel bolts which
have been approved by Mercedes-Benz and
for the wheel in question.
#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated until they are
finger-tight.
#
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is finger-
tight.
#
Lower the vehicle (
/
page 434).
Lowering the vehicle after a wheel change
Requirements:
R
The new wheel has been fitted (
/
page 433).
* NOTE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
ped when the vehicle is lowered.
#
Start the engine. This adapts the vehicle
level.
#
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated 1 to 5 with
an initial maximum force of 80 Nm.
#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated 1 to 5 with
the specified tightening torque of 150 Nm.
434 Wheels and tyres