Mercedes-Benz GLC 200 4MATIC, Руководство пользователя

Страница: 415 / 601

#
After removing the jump leads, close cover
3
of positive contact
2
.
#
Close cover 1 .
If your vehicle has been started with starting
assistance, it may not be possible to use the elec-
tric drive for approximately 30 minutes.
Further information can be obtained at a qualified
specialist workshop.
Charging
#
Connect positive contact 2 of the vehicle to
the positive terminal of the charger using the
charging cable. Always begin with positive
contact 2 of the vehicle.
#
Connect the negative terminal of the charger
and earth point 4 on the vehicle with the
charging cable. Start with the charger.
#
Start the charging process.
When the charging process is complete:
#
First, remove the charging cable from earth
point 4 and the negative terminal of the
charger, then from positive contact 3 and
the positive terminal of the charger. Begin
each time with the contacts of the vehicle.
#
After removing the charging cable, close cover
3
of positive contact
2
.
#
Close cover 1 .
Further information can be obtained at a qualified
specialist workshop.
Replacing the 12 V battery
#
Observe the notes on the 12 V battery
(
/
page 406).
Mercedes-Benz recommends that you have the
12 V battery replaced at a qualified specialist
workshop, e.g. at a Mercedes-Benz Service
Centre.
Observe the following notes if you want to replace
the battery yourself:
R
Always replace a faulty battery with a battery
which meets the specific vehicle require-
ments.
The vehicle is equipped with an AGM technol-
ogy battery (Absorbent Glass Mat) or a lith-
ium-ion battery. Full vehicle functionality is
only guaranteed with an AGM battery or lith-
ium-ion battery. For safety reasons, Mercedes-
Benz recommends that you only use batteries
which have been tested and approved for your
vehicle by Mercedes-Benz.
R
Carry over detachable parts, such as vent
hoses, elbow fittings or terminal covers from
the battery being replaced.
R
Make sure that the vent hose is always con-
nected to the original opening on the side of
the battery.
Fit any existing or supplied cell caps.
Otherwise, gases or battery acid could
escape.
R
Make sure that detachable parts are recon-
nected in the same way.
412 Breakdown assistance