Mercedes-Benz 2016 GLC, Руководство оператора

Страница: 398 / 418

X
Shift the transmission to position P.
X
Make sure that the vehicle level is set to
"Normal" on vehicles with AIR BODY CON-
TROL (
Y
page 196).
X
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove
the SmartKey from the ignition lock.
X
Vehicles with KEYLESS-GO start-func-
tion or KEYLESS-GO: open the driver's
door.
The on-board electronics now have status
0. This is the same as the SmartKey having
been removed.
X
Vehicles with KEYLESS-GO start-func-
tion or KEYLESS-GO: remove the Start/
Stop button from the ignition lock
(
Y
page 153).
X
Make sure that the engine cannot be star-
ted via your smartphone (
Y
page 156).
X
If included in the vehicle equipment,
remove the tire-change tool kit from the
vehicle.
X
Safeguard the vehicle against rolling away.
Securing the vehicle to prevent it from
rolling away
If your vehicle is equipped with a wheel chock,
it can be found in the tire-change tool kit
(
Y
page 355).
The folding wheel chock is an additional
safety measure to prevent the vehicle from
rolling away, for example when changing a
wheel.
X
Fold both plates upwards : .
X
Fold out lower plate ; .
X
Guide the lugs on the lower plate fully into
the openings in base plate = .
X
Place chocks or other suitable items under
the front and rear of the wheel that is diag-
onally opposite the wheel you wish to
change.
Raising the vehicle
G WARNING
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip over with the vehicle raised.
There is a risk of injury.
Only position the jack at the appropriate jack-
ing point of the vehicle. The base of the jack
must be positioned vertically, directly under
the jacking point of the vehicle.
!
The jack is designed exclusively for jack-
ing up the vehicle at the jacking points.
Otherwise, your vehicle could be damaged.
Observe the following when raising the
vehicle:
R
To raise the vehicle, only use the vehicle-
specific jack that has been tested and
approved by Mercedes-Benz. If used incor-
rectly, the jack could tip over with the vehi-
cle raised.
R
The jack is designed only to raise and hold
the vehicle for a short time while a wheel
is being changed. It must not be used for
396
Changing a wheel
Whee
ls
an
d
tires