mensor CPC8000, Руководство по эксплуатации

Страница: 91 / 113

High-End Pressure Controller
CPC8000
Operating Instructions - CPC8000 91
Sensorid? <sp><sensor#><sp>ID<sp>M
ENSOR,<sp><model>,<sp><
SN>,<sp>V<version><cr><lf>
Returns the active sensor’s serial number
and frmware version.
Setpt value inside upper and lower
limits
Sets the control setpoint for the instrument.
Setpt? <sp>+n.nn<cr><lf> Returns the control setpoint in current units.
Setpt% Value in % of current range Sets the control setpoint in % of current
range.
Setptpct Value in % of current range Sets the control setpoint in % of current
range.
Setptpct? <sp>+n.nn<cr><lf> Returns the current setpoint in % of current
range.
Span desired pressure or ? Sets span on active transducer or for ?,
clears previous value, must be > 50% FS
and has a 1% limit. CALDISABLE must be
OFF/NO.
Span? <sp>+n.nn<cr><lf> Returns span scale factor for active trans-
ducer.
Sparity Even, ODD, NONE Sets the serial parity.
Sparity? <sp>CCCC<cr><lf> Returns the serial parity.
Srqmask Stable,Error or both Sets the CPC8000 to issue a service
request (SRQ) over the IEEE when the
pressure control is stable, or an error
occurs. These are 80 hex and 40 hex
respectively.
Srqmask? <sp>{string}<cr><lf> Returns “stable”, ”error” or “error, stable”
depending on the SRQ.
Sstop 1 or 2 Sets the serial stop bits.
Sstop? <sp>X<cr><lf> Returns the serial stop bits.
Stable? Returns Yes if instrument is stable, or No.
Stabledelay 0 to 65535 Sets the stable time to the number of
seconds specifed.
Stabledelay? <sp>XXXXXXX<cr><lf> Returns the stable time.
Stabletime 0 to 65535 Sets the stable time to the number of
seconds specifed.
Stabletime? <sp>+n.nn<cr><lf> Returns the stable time.
StableWin %fs value Sets the stable window as a %FS.
StableWin? <sp>+n.nn<cr><lf> Returns the stable window.
Standby None Instrument placed in Standby mode
Standby? <sp>(YES or NO)<cr><lf> Returns yes if instrument is in Standby, no if
otherwise
Step value inside upper and lower
limits and inside the range of
the active sensor
Sets the control step size for the instrument