42
How to move the Backup DC Power Inlet Port
To move the Backup Battery Power Inlet Port to a new location, follow these instructions.
1. Locate the DC Power Inlet Port connector which is mounted directly beneath the Master Switch.
2. A large cutout exist on the left side of the unit which will give you direct access to the rear of the Backup DC Inlet
Port fitting.
3. Loosen and remove the securing nut for the Inlet Port fitting then lift it up and out carefully while guiding the wires
through the open slot.
4. Carefully pull the Inlet Port fitting and its connecting cable out
of the body of this appliance through a hole provided at the
front of the Left Control Panel.
5. Determine where you wish to mount the DC Inlet Port (front
face or left side return flange).
6. Push the partially cutout knockouts through carefully using a
small screw driver.
