34
10.
Loosen Pilot Light’s hex shape base using a ½” open end wrench. Rotate counter clock-wise ¼ turn to loosen.
11. Pilot arrives from the factory set for NG. Push NG/LP Adjustment Clip inward all the way to set it for LP. See detail
view, below. If you see “NAT” printing on the Adjustment Clip, this indicates that the pilo
t is set to burn NG. Push Clip in
so that “NAT” is not visible.
12. Tighten down Hex shaped base of pilot using a ½” open end wrench.
13. Before reinstalling the burner, loosen the screw that secures the rotary air shutter on the Front Burner. Rotate the
air shutter open to ¼” minimum. For high altitude installations, open to 3/8” minimum.
14. Install burner in its original location and position and secure down using 3/8” nuts you removed earlier.
15. Make certain burner is running parallel to front face of unit positioned properly.
