Mendota FV42-0518, Инструкция по установке и эксплуатации

Страница: 64 / 84

6 4
FV42 85-03-01068
INSTALLATION CHECKLIST
All items on the checklist must be completed.

Co-axial vent rigid pipe, wall vent cap or roof vent cap is installed by a Mendota approved
serviceperson in accordance with instructions.

All joints are secured, "twist-locked" and leak-proof. 1000°F sealant is used on the inner pipe joints
of all DuraVent pipe sections.

Horizontal or vertical vent cap is installed "right-side-up" and tightly sealed to structure per
instructions. Vent Caps are Mendota approved.

Proper exterior and interior clearances for vent systems and locations for wall vent cap/roof vent cap
are maintained.

Correct gas pressure, proper size gas lines and gas leaks are checked.

120 V electrical service and gas supply is installed in accordance with instructions and local and
national codes.

Telescoping sections are not separated. They were used as complete assemblies.

Glass door is in proper closed position and centered in firebox opening.
LIGHTING CHECKLIST
All items on the checklist must be completed.

Gas leaks and gas pressures prior to installing facing materials is checked.

Fresh batteries are in remote control. Follow “First-Time Lighting Instructions” to synchronize the
remote control and the ignition module.

Air shutter opening 0" to ⅛" natural gas or ¼” to ½” LP gas is checked.

All lighting and log installation instructions were followed.

Burners light immediately and flame runs promptly around rear burner and lights entire burner.
Note: Do not proceed with operation unless burner cycles "on/off" without delays.

Flame is "stable" and does not "lift" off burner. If flame lifts off burner, turn unit off and check that
all vent pipes are "twist locked" and leak proof, the vent cap is "right side up" and that 1000°F
sealant has been used on the inner pipe joints of all DuraVent pipe sections. Do not proceed with
operation if flame is "lifting off" burner.
f i r e - p a r t s . c o m