Melco EP 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 44

2-3
The Bobbin Case
Removal
1. After turning off the power switch, lift the needle
above the throat plate by rotating the flywheel.
2. Remove the auxiliary table by lifting slightly at its
left front and sliding it off to the left.
3. Open the bed cover by placing your finger at the
left rear of the cover and flipping it forward and
down to its opened position.
4. Pull out the bobbin case lever and remove the
bobbin case from
NOTE: The hook area must be kept clean to avoid
thread breakage problems! If you find any
thread debris at this time, clean it out.
Winding Thread Onto The Bobbin Reel
The bobbin winder can wind bobbin thread anytime, even while
embroidering, because the bobbin winder is an independent part of
the embroidery machine.
1. Attach the bobbin reel onto the bobbin winding shaft, and push
the bobbin winding shaft downward.
2. After hooking the bobbin thread onto the thread guide above the
bobbin thread cone, route the thread through the first thread
guide, and then the second guide, in this order. Each thread
guide features a thread path diagram, as shown in Figures 2-13
and 2-14.
3. Pass the thread through a bobbin reel hole from the inside
of the wall to the outside.
4. Press and hold the [SPOOL] key until the bobbin begins
turning.
NOTE: If the [SPOOL] key is not held down long enough, the
bobbin will not turn.
11034 Rev. A 2. Needles, Bobbins, and Threads
Figure 2-11
Figure 2-12
Figure 2-14
Figure 2-13