1-1
1. Setup
The setup procedure for the EP 1 Embroidery Peripheral is easy and will only take a few minutes.
1. Carefully remove the machine from the shipping container, using care not to drop or damage
any other items packed around it. The machine is heavy, so be careful. Place the machine on a
sturdy table or work bench.
NOTE: Be sure to save the shipping container and packing supplies that your embroidery periph-
eral came in. If your machine should ever require factory service, it should be returned in
the original (or other equally suitable) shipping container.
2. Make certain the machine’s power switch is turned to the OFF position.
3. Plug one end of the power cord into a wall outlet. A
surge protector is recommended but not required.
Plug the other end into the machine.
4. Connect the peripheral to your controller or host
computer using the network cable. Plug the net-
work cable into
either
of the network ports, as
shown in Figure 1-1. Plug the terminator cable into
the other network connector. It does not matter
which cable is plugged into which connector.
5. Your machine may have come with a needle already
installed, but it is a good idea to start your sewing
with a new needle.
6. Locate the thread guide bar and gently pull it
upward until it reaches its maximum height. It will
extend like a car antenna. Rotate the guide bar until
the ends are aligned over the thread cones on the
base below (see Figure 1-2).
7. Your machine may have come with thread already
loaded on the bobbin, but check to make certain.
8. Load a spool of thread onto the thread stand and
thread the machine as required.
At this point your EP 1 should be ready to begin sewing.
If you should encounter any problems during this procedure, contact your local Melco representa-
tive for assistance, or call Melco’s Technical Support line.
11034 Rev. A
1. Setup
Figure 1-1
Network cable
Terminator cable
Figure 1-2
Содержание EP 1
