Melco EP 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 44

3-3
After sending a design to the EP 1, follow the steps below:
1. Press [MENU] until the display reads DESIGN MENU.
2. Press [ENTER] to display the design. Select from the available designs by using the [
ò
] or [
ñ
]
keys.
3. Press [ENTER] again to select the design in the display. The display will then read RUN DESIGN.
4. Press [ENTER] once again to set the design queue.
5. Press [MENU] until the display reads TRACE MENU.
6. Press [ENTER]. The display will read CENTERING OFF.
7. Press the [
ò
] key. The display will read TRACE OUTLINE. Press [ENTER] to calculate the trace
area. The display will read TRACE DESIGN.
8. Press [START] to trace the design.
If the hoop needs to be moved for embroidery, use the appropriate arrow keys, then press [START]
to trace the design again.
9. Press [ENTER] to prepare the EP 1 for embroidery.
10. Press [START] two times.
11. When the design is finished embroidering, the display reads END OF DESIGN. Press [START] to
embroider this design again, or press [MENU] until the display reads RESET MENU to change
designs.
12. Press [ENTER] four times (until the display reads MACHINE 01 READY.
13. Repeat procedure for the next design.
NOTE: If you lose your place during this sequence, go to the RESET MENU and press [ENTER] four
times. It is easier to reset and start again than to back out of an error.
11034 Rev. A 3. Embroidery Hoops