Melco EP 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 44

2-4
EP 1 Operation Manual Melco Embroidery Systems
5. After the thread has been wound completely, the bobbin reel will continue to spin for a few
moments before stopping.
6. After the bobbin reel has stopped turning, cut the thread and remove the bobbin reel from
the bobbin winding shaft.
7. If the thread was cut or if thread cannot be wound on the bobbin reel normally during thread
winding, the thread winding can be stopped by pressing the [SPOOL] key again.
Setting the Bobbin
After thread has been wound onto the bobbin reel and the bobbin reel is placed into the bobbin
case, install the bobbin case into the hook body.
NOTE: Turn the power switch OFF when putting the bobbin case into the hook body.
1. Hold the bobbin case in your left hand so the open side is facing toward you.
2. Hold the bobbin reel in your right hand.
NOTE: It is recommended that you orient the bobbin reel so the thread is coming off in a clock-
wise direction. However, some users feel that orienting it with the thread coming off in a
counter-clockwise direction is better. Either way is acceptable.
3. Place the bobbin reel into the bobbin case.
4. Grasp the end of the thread, and pass the thread into the bobbin case slit.
5. Draw the thread under the tension plate and out the opening in the bobbin case, then pass
the thread into the hole of the bobbin case horn (use the aid of the threader if desired).
6. Draw out the thread about 4 inches (10cm).
7. Set the bobbin thread tension.
Installation
1. To install the bobbin case into the hook body, pull out the bobbin case lever as you do when
you remove the bobbin case (the bobbin does not
fall out of the case when the lever is held out).
2. Position the bobbin case horn so it points
upward. Set the horn into the concave portion of
the hook body as you insert the bobbin case onto
the post in the middle of the hook body.
3. Release the bobbin case lever and check that the
lever has grasped the end of the post, thus secur-
ing the bobbin case in the hook body.
Figure 2-15