Melco EP 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 44

5-1
5. Configuration
The EP 1 allows you the option of setting the unit number, display brightness, and volume of the
key clicks and error beeps.
Unit Number
If you have several embroidery machines hooked up to one computer, each machine must be
assigned its own unit number. Each EP 1 is set at the factory as unit #1 but you can change that
number easily.
1. With the machine power OFF, hold down the [ALT] and [
ò
] keys and keep holding them down
while you turn the power ON. Once the power is on, release the keys and the display will
read: UNIT NUMBER _ _. Press [ENTER] and the display will read UNIT NUMBER 01.
2. Change the unit number by pressing the [
ñ
] or [
ò
] keys until the display shows the number
that you want.
3. Press [ENTER] until the display reads: MEMORIZE & EXIT.
4. Press [ENTER] again to “save” the unit number.
5. Turn the machine power OFF, wait a few seconds, then turn it back ON. When the machine
powers up, the display will show the new unit number.
NOTE: If the power is turned off before completing this procedure, the setting will not be saved.
Display Brightness
The LCD can be set at several different brightness levels.
1. With the machine power OFF, hold down [ALT] and the [
ò
] key and keep holding it down
while you turn the power ON. Once the power is on, release the key and the display will read:
UNIT NUMBER _ _. Press the [
ò
] key and the display will read BRIGHTNESS. Press [ENTER] and
the display will read BRIGHTNESS 50.
2. Change the display brightness by pressing the [
ñ
] or [
ò
] keys until the display is at the right
brightness setting for your particular needs.
3. Press [ENTER] until the display reads: MEMORIZE & EXIT.
4. Press [ENTER] again to “save” the brightness level.
5. Turn the machine power OFF, wait a few seconds, then turn it back ON. When the machine
powers up, the display will be at the new brightness setting.
NOTE: If the power is turned off before completing this procedure, the setting will not be saved.
11034 Rev. A 5. Configuration