4.1.1.12 Programmable Pulses
If the system has programmable switching outputs, you can configure the parameters in this menu.
Mode:
Output signal configuration.
Pulse length (ms):
Pulse length configuration.
Cycle:
For "Cycle Pulse" mode, an interval can be configured in hh: mm: ss.
Time:
In the configured mode "Single Shot", the time for the pulse can be parameterized
in
hh:mm:ss
.
DCF Suspend
After (min):
In the "DCF77 Marks" mode, you can configure a shutdown time for the output port,
so that in the case of an asynchrony of the reference clock, no DCF mark is available
at the output.
On / Off Time:
For the "Timer" mode, it is possible to configure start and stop times in
hh:mm:ss
.
Signal:
Configuration of the output signal active in high or low.
Disable output
If the reference clock is asynchronous, the output signal is immediately deactivated
in Holdover mode:
when the checkbox is activated.
Note:
In the clock-submenu "Enabling the Outputs" the Pulses option "if sync"
must be select so that the outputs can be switched off in holdover mode.
20
Date: 20th March 2020
IMS-GNS181 Setup Guide
Содержание IMS-GNS181
Страница 1: ...MANUAL IMS GNS181 Setup Guide Hot Plug Module 20th March 2020 Meinberg Funkuhren GmbH Co KG...
Страница 2: ......
Страница 53: ......
