Meiko TopClean M, Инструкция по эксплуатации, Страница: 17 / 54

9018116 17 / 54
• Transport with care.
• Open packaging using a suitable tool.
• Only unpack the cleaning and disinfection machine after transportation.
7 Assembly
Warning
Danger of injury from entering a danger zone
Unauthorised persons might be in or enter the danger zone during transport, as-
sembly, commissioning, maintenance and repair work. This can lead to injuries.
• Only permit qualified persons to perform work at the machine.
• Remove unauthorised persons from the danger zone.
• Cordon off danger zone and signpost it for third parties.
• Never remove or disable safety devices on the machine.
• Always wear cut-resistant protective gloves when removing housing parts and
when working inside the machine!
7.1 Prerequisites for assembly
7.1.1 Checking the condition at delivery
• Check that the delivery is complete immediately after receiving it by comparing
it with MEIKO’s order confirmation and/or the delivery note.
• If applicable, submit a claim for any missing parts immediately to the freight for-
warder and notify MEIKO.
• Check the machine for transportation damage.
Note
If there is any suspicion of transportation damage, the shipping company and
MEIKO must be informed immediately in writing. Photograph any damaged parts
and send the pictures to MEIKO.
7.1.2 Requirements for the installation area
The cleaning and disinfection appliance is only frost-proof in as-delivered state or if
equipped with special features (option: frost drainage).
Installation of the cleaning and disinfection machine in an area where the ambient
temperature is below 0° C can result in damage to the internal water circuit compo-
nents (e.g. pump, solenoid valve, boiler, etc.).
• Make sure that the storage and installation site are always frost free.
• Make sure that the ground beneath is capable of taking the load, level and hori-
zontal.
There is a danger of slipping in the working area due to the use of water.
• After assembly, put in place non-slip floor coverings in the working area based
on the general/location-specific safety regulations.