Megger TM1800, Руководство пользователя

Страница: 57 / 104

CG0757JE ZP-CG01E TM1800 57
6 CABA LOCAL
6.12 Analyzer view menu
The Analyzer View visualizes the link between
TM1800 and the test object. In Analyzer View you
obtain information about your system configuration,
channel occupancy, hook-up instructions and so on.
When entering the Analyzer View the hook-up screen
is shown.
„ „
The screen shows all modules that are installed and where
they are located in the system
„ „
Channels that are, due to the definitions made in breaker
view, not used are marked Off.
„ „
The usage for all active channels are stated e.g. Close for
the upper channel of the first Control Module.
„ „
Each active channel can be marked with the cursor with
the help of the arrow buttons on the left hand side of the
screen or by using the mouse/trackball.
Hook-up instructions
1]
Mark any channel and press the “i” button
in the middle of the right hand side of the
screen upon which the system provides you
with the information on how to connect.
Below is an example.
2]
Press the “i” button a second time to go back
to monitor view.
Select transducer
If you in Breaker View, Motion measurement prefer-
ences have selected Absolute (see section 6.12) “Se-
lect Transducer” is blinking on the active channel.
1]
For selecting a transducer press the “SELECT”
button whereupon the transducer list ap-
pears.
2]
Select the appropriate transducer and press
the “Select” button.
Now the transducer is selected which then is indicated by
displaying the transducer name at that specific channel.
Monitor
1]
By pressing the “MONITOR” button you will
see information about the actual breaker
measurement and status.
Note
To get information from control modules con-
nect blue cable to NC and red cable to OUT.