Megger TM1800, Руководство пользователя

Страница: 34 / 104

34
TM1800 ZP-CG01E CG0757JE
5 INSTALLING/REMOVING MODULES
5
I
nstalling/removing
modules
5.1 Installing a module
Choose a slot (1-8) for the new module. Slot number
10 is dedicated for the HDD module.
IMPORTANT
Use ESD bracelet when removing module
covers or modules.
Do not remove any other covers, but the
covers for the modules.
1]
Turn off TM1800.
2]
Disconnect all cables including voltage supply
to TM1800.
3]
Remove the dummy module (use a Torx
T10 screwdriver, included in the delivery of
TM1800).
4]
Push the module gently, straight into the
slot. Make sure the contact terminal fits cor-
rect into the socket-contact in the bottom of
the slot.
5]
Fasten the module using all the four screws
and washers.
6]
Save the dummy module. It has to be in-
stalled again if you remove a module.
Tip
You do not need to loosen the screws en-
tirely, see picture below. The screw holes
in the module covers are treaded and the
screws has a waist to prevent losing the
screws.
IMPORTANT
Replace worn or damaged screws and
washers.
This is important to ensure a good protec-
tive earth (ground) connection.
Slots number 1 to 8 must have a module/
Dummy module mounted to achieve a
correct cooling of the TM1800.