Megatron UP-PN-II, Руководство пользователя

Страница: 31 / 36

31 UP-PN-
II
v0.8
•
GS [ n1 n2 (1D 5B Hex = 29 91 Dec)
Sends on serial the config followed by 2 bytes n1 and n2.
At the reception, the parameter for group n1 and field n2 is sent on the inter-
face in text format.
n1 : Selects group. (01 hex to number of groups)
n2 : Selects field (01 hex to number of field)
The information sent are the same than those returned by the config com-
mand.
Example:
GS [ 03h 01h
asks for the field baud for the group serial
The printer then sends :
Serial ->Baud =9600 Baud
4.5.10 S
YSTEM
C
OMMANDS
The following commands are used by the system. Do not use them.
•
GS <FA> (1D FA Hex=29 250 Dec)
Printing of the logo on event timer
•
GS <FC> <datas> (1D FC Hex=29 252 Dec)
Burns firmware. (reserved)
•
GS <FD> <zone> <Low> <High> <datas> (1D FD Hex=29 253 Dec)
Burns a flash bank (reserved)
•
GS a n (1D 61 Hex=29 97 Dec)
Prints the actual values of paper end sensor and power voltage. (ADC value,
10 bits)
•
GS \ n1 n2 (1D 5C Hex = 29 92 Dec)
Scaling of paper end sensor & power supply voltage.
•
GS " n (1D 22 Hex = 29 34 Dec)
Goes to hex mode