Megatron UP-PN-II, Руководство пользователя

Страница: 10 / 36

UP-PN-
II
v0.8 10
2.4 Replacement of ink ribbon
The ink ribbon must be replaced when the printing becomes too light. Follow
these steps :
1 Open the case
2 Push on the ribbon where it is written. (fig 2.4) and remove the ribbon
3 Place a new one instead. The paper must be inside the ribbon. Turn the little
wheel on the ribbon until the ribbon is tight.
4 Close the case
2.5 Selecting the interface
Use the configuration menu for select IrDA, RS232 or USB 2.0.
1) Serial Interface RS-232C :
Set the menu « Printer -> Interface » on « serial »
The whole set of parameter must match the host.
2) Infrared IrDA:
Set the menu « Printer -> Interface » on « IrDA/Ser9K6 » or « IrDA/USB »
The baud are automatically adapted to the host.
The protocol supports IrLPT et IrCOMM-3 wire Raw
RS232 baudrate is limited to 9600 Baud
3) USB Interface :
Set the menu « Printer -> Interface » on « IrDA/USB ».
Figure 2-4 Ink ribbon