Medrad AngioJet Ultra, Руководство по эксплуатации

Страница: 8 / 16

Status Panel: Provides instructions, procedure status, and alarm resolution
strategies.
Power Button: Press to activate the control panel.
Alarm Reset Button: Press to clear or override an alarm.
Catheter Button: Displays catheter model installed in the AngioJet
Ultra Console. Press this button to see a 3-second display of catheter
model.
Scroll Buttons: These buttons are active only when there is
more text to be displayed than can fit on the status panel
screen. Press the DOWN button to advance one screen
forward; press the UP button to return to the previous screen.
Counter Reset Button: Press this button to return the time
display and infused volume to zero.
NOTE: You cannot use the COUNTER RESET Button to override the time needed
for priming the catheter.
NOTE: The Ultra System is designed to be interactive. The status panel will
provide prompts to guide the technician through set-up as well as
provide error resolution when necessary.
Preparation of the Ultra System requires the assistance of a sterile and a
nonsterile technician. The catheter is used within the defined sterile field,
the Console and pump are operated outside the sterile field. The following
directions are for the nonsterile technician except where otherwise noted.
1
Plug in the Console and ensure
the main power circuit breaker
switch is turned
ON (Figure 4).
2
Heparinize a bag of sterile, room-temperature
saline at a suggested rate of 5000 units per
liter of saline and mix contents (a 1.0 liter bag
is recommended, but is not included with the
Ultra System). Hang the saline bag on the saline
bag hook at the top of the Console.
3
Press the POWER button on the control panel.
7
Figure 4
7.1 Prepare Console
Main Power Circuit
Breaker Switch