Sentinel 100 - Hardware Installation Guide
18
media5corp.com
Result
You can now use the 192.168.0.10 IP address to access your unit's management interface.
Using IPv4 to Connect the Mediatrix unit in the LAN with a DHCP
Before you start
•
Make sure that your network connection is working.
•
If your unit does not have an FXS port, or if you do not have access to the DHCP server's
logs, then use the
Using IPv4 to Connect the Mediatrix Unit in the LAN w/o a DHCP server (p. 19)
procedure.
Steps
1)
Make sure an adequate earth ground connection has been made between the grounding
screw on the back of the Mediatrix unit and an appropriate grounding point in your site.
Warning
:
Adequate earth grounding connection of the Mediatrix unit is mandatory to avoid
any damage or injuries.
2)
Wear an ESD wrist strap, ensuring it makes good contact with your bare skin.
3)
Attach the ESD wrist strap end to an earth ground (grounding screw on the back on the
Mediatrix unit or unpainted bare metal spot of a grounded equipment rack).
4)
Make sure the unit's power switch is OFF.
5)
Make sure the circuit breakers of power sources used to power the Mediatrix unit are OFF.
6)
Make sure the provided AC power cord is connected into the POWER connector located on
the back of the Mediatrix unit and in an appropriate AC electrical outlet.
7)
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH1 connector of the Mediatrix
unit.
8)
Connect the other end of the cable to a router/switch connected to your Network.
9)
Validate the installation.
10)
Turn ON the power sources that are used to power the Mediatrix unit at the circuit breaker.
Note:
When the unit is brought from a cold to a warm environment, condensation, that might be
harmful to the unit, may occur. If this is the case, wait one hour before connecting the power cord.
11)
Turn On the power switch of the Mediatrix.
12)
If you have an FXS port, dial *#*0 to get the IP address or consult the DHCP server's logs
to find out your IP address.
