Mecmesin MultiTest 0.5-dV, Руководство по эксплуатации

Страница: 19 / 52

MultiTest -dV Operating Manual
Mecmesin
 19
4.10. Fitting an ELS to a Test stand
MultiTest
-dV
test stands with
dV
(u) mode enabled use Mecmesin ELS devices to capture
load readings.
To fit an ELS to the test stand slide the load cell sideways onto the dovetail and tighten
the grub screw (circled below in red) located in the dovetail using a suitable Allen key.
To prevent damage, do not over-tighten the grub screw in the dovetail when a gauge
bracket is not present.
Note: Take care when handling low capacity ELSs such as a 5N cell, as damage can
easily occur from mishandling.
It is also vital to ensure that the attached grips and fixtures do not overload the ELS. If
in doubt, please check the weight of any addition grips and fixtures before fitting these.
 MultiTest -dV Dovetail, note the grub screw circled in red