Mean Well SHP-10K-115, Руководство по установке

Страница: 28 / 33

49
byte1:
Bit 0:3 VIN Factor： The Factor of AC input voltage
0x0= AC input relevant commands not supported
0x4=0.001
0x5=0.01
0x6=0.1
0x7=1.0
0x8=10
0x9=100
0xA~0xF= Reserved
Bit 4:7 FAN_SPEED Factor： The Factor of fan speed
0x0= Fan speed relevant commands not supported
0x4=0.001
0x5=0.01
0x6=0.1
0x7=1.0
0x8=10
0x9=100
0xA~0xF= Reserved
byte2:
Bit 0:3 TEMPERATURE_1 Factor： The Factor of internal ambient temperature
0x0=internal ambient temperature relevant commands not supported
0x4=0.001
0x5=0.01
0x6=0.1
0x7=1.0
0x8=10
0x9=100
0xA~0xF= Reserved
6
50
◎
SYSTEM_STATUS (0x00C3) ：
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0
Low byte
PFC OK _
- - EEPER
INITIA-
LSTATE
ADL_ON
DC_OK
M S /
Bit 1 DC_OK：Secondary DD output voltage status
0＝Secondary DD output voltage status TOO LOW
1＝Secondary DD output voltage status NORMAL
Bit 2: PFC_OK：Primary PFC status
0＝Primary PFC OFF or abnormal
1＝Primary PFC ON normally
Bit 4 ADL_ON：Active dummy load control status
0＝Active dummy load off/function not supported
1＝Active dummy load on
Bit 5 INITIAL_STATE：Device initialized status
0＝In initialization status
1＝NOT in initialization status
Bit 6 EEPER：EEPROM data access error
0＝EEPROM data access normal
1＝EEPROM data access error
Note: Unsupported settings displays with "0"
SYSTEM_CONFIG (0x00C4)：
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0
Low byte - - - - - OPERATION_INI MOD_CTRL
Low byte:
Bit 0
_CTRL：Modbus communication control status MOD
＝The output voltage/current defined by control over SVR/PV/PC 0
1＝The output voltage, current, ON/OFF control defined by control over
Modus (VOUT_SET, IOUT_SET, OPERATION)
Bit 0: M/S：parallel mode status
0＝Current device is Slave
1＝Current device is Master
6