9
ISOBUS-TC task processing
Configuring the list of connections
64
V7.20160121
30302710-02-EN
⇨
The following screen will appear:
2.
- Select and click on the "Work with ISO-XML?" line.
⇨
The mode will change with each click.
3. Set the desired mode.
4.
- Restart the terminal.
⇨
The set mode will be activated after restart.
Configuring the list of connections
The list of connections indicates the ISOBUS job computers from which the terminal will load the
geometries of the connected implements. This geometry is required in order to calculate the position
of all implement components on the basis of the GPS signal. Only in this way are precise parallel
driving and section switching possible.
The farm equipment must be ordered consecutively from the front to the rear when viewed in the direction of
travel
Tractor ECU of the terminal.
Name of the job computer
Connectors between the "ME-Tractor-ECU"
application and "ME_ISO_Spritze". The
geometries of this equipment is transferred to
SECTION-Control.
Not all of the equipment in the list must be
connected. Job computers which contain no
relevant geometric data can be disconnected.
In the image, the "Tractor" job computer has
been the disconnected, as the tractor
geometry should be transferred from the
Tractor-ECU application of the terminal.
ISOBUS job computer "ME_ISO_Spritze"
If you are not using the ISOBUS-TC application, you can configure the list of connections as follows:
All ISOBUS job computers are connected to the ISOBUS.
9.3
Procedure
