MDT Technologies BE-GT20S.02, Техническое руководство

Страница: 20 / 99

Technical Manual
Glass Push-button II Smart & Push-button Smart 86 [Series .02]
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Germany
Phone: +49-2263- 880 • knx@mdt.de • www.mdt.de
20
20
Adapt display brightness to ambience : not active
Brightness „Day“ 1 – 100 %
[10 %]
Setting a fixed brightness value in
Day mode.
Brightness „Night“ 1 – 100 %
[3 %]
Setting a fixed brightness value in
Night mode.
Adapt display brightness to ambience : active
Brightness Brightness level 1 – 10
[Brightness level 8]
Setting the basic brightness of the
display.
Minimum brightness „Day“ 1 – 100 %
[10 %]
Setting of the brightness that cannot
be undercut during dimming in “Day”
operation.
Minimum brightness
„Night“
1 – 100 %
[3 %]
Setting of the brightness that cannot
be undercut during dimming in
“Night” mode.
Send brightness via object
to the bus
▪
not active
▪
active
Setting whether the current display
brightness is sent.
Display switch-off in
Standby
▪
not active
▪
active for „Night“
▪
active for „Day“ and
„Night“
Setting for which operation the
display switch-off should apply.
Switch-off threshold
▪
threshold 1
(moderately dark)
▪
threshold 2 (dark)
▪
threshold 3 (very dark)
Setting at which threshold the
display should switch off.
Only visible if the display switch-
off is "active".
Table 9: Display settings – Adaption to ambience
Principle of brightness adjustment
The Push-button Smart has an internal brightness sensor and can dynamically adjust the display
brightness to the environment. The "Brightness" parameter influences the dimming behaviour and
the threshold from which the display is dimmed. The parameter for the minimum brightness defines
the absolute lowest threshold up to which the display is dimmed.
In the programmed state, the menu for setting the brightness can be called up by simultaneously
pressing sensor surfaces 7 and 8. The brightness is set by pressing/touching the surfaces/buttons
1/2. Pressing/touching the surfaces/buttons 3/4 sets the minimum brightness:
In this menu, the end user can adjust the brightness settings independently (without ETS). The
settings made are permanently stored in the unit until the next time the database is transferred.