Extreme 7" Monitor/DVR System
© 2019 McNeilus Truck and Manufacturing, Inc.
42
Preco PreView Radar System
2. Once the location for the sensor is tested and approved for use, the sensor may be mounted directly on the
vehicle, or mounted using the supplied bracket (Figure 23).
Figure 23
If the mounting bracket is not used, follow these steps to mount the sensor directly on the vehicle.
Remove the template and discard.
•
Drill 1/4" (6 mm) holes. Also drill a 1-1/2" diameter clearance hole for the sensor connector and mating cable
as indicated on the template.
•
Secure the sensor to the vehicle using the (4) 1-1/4" x 10-24 bolts, (4) 1-1/4" x 10-24 locking hex nuts, and
the (4) 1-1/4" x 10-24 flat washers. Torque the bolts to a maximum of 22 in.-lbs.
•
Mount and Install the VideoLink
The VideoLink (PN 1483927) is mounted in the cab between the camera system cable and the Extreme Monitor/
DVR system. Installation of the Buzzer Kit (PN 1483944) is recommended (see
instructions for the buzzer kit).
1. Disconnect the existing camera system cable from the monitor.
2.
Connect the 1483926 Monitor Adaptor/Cable between the monitor and the camera cable.
3.
Plug the black Deutsch connector from the 1483926 Monitor Adaptor/Cable into the VideoLink (see
24).
Figure 24
1483926 Monitor Adaptor/Cable and
1483927 VideoLink
