Page 7
Entering Program Mode
There are two codes that will allow access to the product range of panels for
programming. The technician code that will allow access to all programmable
functions and the master user code which allows access only to user code
programming. Either code can
only
be used in the OFF mode and since the
operation of both codes is similar, only the technician code will be discussed.
DEFAULTING THE PANEL
If the technician and master codes are not known the only way to enter program mode is to default
the panel so the factory preset codes may be used. This is accomplished by removing power from
the panel and then reapplying power with
ANY
key on the keypad pressed for three seconds. This
will restore the factory technician and master codes which are
2 1 8 0 6 7
and
2 1 8 5 7 2
respec-
tively and all other settings to default and will be indicated by
five
beeps from the Keypad.
NOTE :
Defaulting the panel will reset
ALL
functions to the factory presets.
ENTERING PROGRAM MODE
To enter the program mode the following sequence is entered :
2 1 8 0 6 7 - On
(Enter technician code and press the On key)
At this point the Program LED will begin flashing to indicate that you are in program mode and the
required function number may now be entered. If an error was made in entering the code or an
incorrect code used, the keypad will give a long error beep after which you may try again function
number again. Program mode will auto exit in approx 10mins.
Assuming we are in program mode the following examples will show how functions are programmed
or changed.
Example 1
To program or change the primary phone number (Function 64) to 02 - pause - 1234567. With the
program LED flashing enter the following :
6 4
(Select Function 64. Program LED will light steady.)
0
2
(First two digits of phone number.)
partial
(Pressing partial key = 1 second pause.)
1 2 3 4 5 6 7
(Remainder of phone number.)
On
(Stores phone number. Program LED will flash.)
At this point the installer can either program further options or leave the program mode by pressing
the '
off
' key.
Example 2
Program sectors 1 and 8 to be entry/exit sectors (Function 49). With the programming LED again
flashing enter the following :
4 9
(Select Function 49. Program LED will light steady.)
0 1 0 8
(Enter sectors 1 (01) and 8 (08) LEDS will flash.)
On
(store information and exit function 49.)
Off
(Exit program mode. Program LED will extinguish)
Содержание iRIS8+
Страница 1: ......
Страница 3: ...Page 3 ...
