MCK EXTender 7000, Руководство по установке

Страница: 31 / 85

EXTender
TM
7000 Installation Guide Page 31
WAN Port Setup
The EXTender has two WAN ports (WAN 1 and WAN 2). The ports communicate via an RS-232, RS-530 or
V.35 interface and provide the connections to the third party network devices.
The following settings are available to the system administrator to manage these WAN ports:
1. Access the WAN 1 or WAN 2 Menu using the following path:
MI Path
Configuration->WAN->WAN_1 (or 2)
2. The following menu appears. Press the
→
key to access the Enabled parameter.
Figure 3-8: Enabling WAN 1 or 2
3. Press the
→
key to change the availability of the port to: Enabled ( Yes ) or Disabled ( No ).
4. Press the
←
key to accept changes and go back to the Configuration Menu .
5. Press the
↓
key to the Save parameter.
6. Press Enter to save changes to the active config (. rem ) file.
Setting Description
Enabling/Disabling WAN ports Individually Enable or Disable a specific WAN port (see below).
Setting the Sync Rate Sets the specific WAN port to the sync rate (synchronous serial port
transfer speed) of the network device (CSU/DSU).
Setting the Mode (signalling proto-
col) Choose the interface signaling type used to communicate with the
network device.
Choosing the Interface Type The interface type for the EXTender 7000 is DTE (Data Terminal
Equipment).