EXTender
TM
7000 Installation Guide
Page 18
Table 2: EXTender 7000 Connections
Letter
Label
Cable Type
Description
A
Console
DB-9
Direct serial connection to a PC for administration.
(DCE)
See “Serial Console Connection and Setup on page’ 20.
Note: Set the COM port as follows; Baud rate: 9600,
Databits: 8, Parity: none, Stopbits: 1, Software flow con-
trol: XON/XOFF
B
Modem
DB-9
Direct serial connection to a modem for remote access.
(DTE).
Note: Set the COM port as follows; Baud rate: 9600, Dat-
abits: 8, Parity: none, Stopbits: 1, Software flow control:
XON/XOFF
C
100-240V
Power
Connect to a 120VAC outlet.
Connect as the last step (see “Power-Up on page’ 22.)
D
ANALOG
(in North
America only)
RJ-11
Connects to an analog line for local dialing. The port will
only support a dedicated analog circuit.
Note: This port will not provide PBX functionality or fea-
tures.
E
Network Inter-
face/WAN3
Expansion
Port
If purchased, the MCK T1/PRI card will be installed here.
The MCK T1/PRI card has two RJ-48C ports which ter-
minate T1, FT1, and PRI lines.
F
LAN
RJ-45 Ether-
net
(10/
100baseT)
Used for connecting the unit to the LAN for use in Voice
over IP (RVP_IP) applications.
Aux LAN
RJ-45 Ether-
net
(10/
100baseT)
Used for administrative purposes. (Telnet, FTP and
HTML)
G
WAN1
WAN2
DB-25,
serial,
straight-
through
Used for a synchronous serial connection. Connect to a
FRAD, CSU/DSU, or other network device.
Note: An RS-530 type cable or DB-25 to M34 cable
should be used for high-speed links to V.35 equipment.
DB-25,
serial, cross-
over
Used for Add/Drop Traffic .
H
Telephony
Interface
RJ-21 (CAT
3)
Wire to a punch down block and then to the telephones.
(see“Pin Assignments (25-Pair Cable) on page’ 19)
Содержание EXTender 7000
