MCK EXTender 7000, Руководство по установке

Страница: 22 / 85

EXTender
TM
7000 Installation Guide Page 22
Power-Up
1. Once the VT-100 program is set up, plug the unit into an AC outlet. The device will begin a series of self-
diagnostic tests, which are displayed as a series of LED flashes. During the power-up sequence,
observe the Power, WAN and Port LEDs on the front of the EXTender.
Figure 2-6: Back of Unit
VOIP Notes:
• If you are connecting an EXTender to an IP network, the unit needs to be assigned an IP address.
• Once the power-up sequence has finished, the state of the following LEDs should be Green.
LED States:
PWR: Solid Green
WAN 1: Solid Green (Ready) if a synchronous device is connected to WAN 1.
Port LEDs : Solid Green if connected properly to the telephones.
IMPORTANT:
If any of the LEDs DO NOT power as explained, refer to the System Administrator’s
Guide for troubleshooting information.
Figure 2-7: Front of Unit
On initial power-up (or before the configuration file has been changed) the Management Interface will ask
you to run the “Setup Wizard” to select the proper PBX/KTS protocol.
• If you type “Yes” the wizard will ask you to select the PBX type.
• If you type “No” the PC displays the following message:
Press “Enter” to start the shell…..
Note: If the EXTender is powered up prior to opening the terminal program, this message will not
appear.
2. Go to “The Management Interface on page’ 23 .
P O R T 1 P O R T 2
LNK
CLN
LAN
0
WAN 1 WAN 2
100-240 V ~ 1.4A MAX 50-60 Hz
TELEPHONY INTERFACE
LNK ACT LNK ACT
AUX LAN LAN
AC Power
NETWORK INTERFACE
PORT 1 PORT 2
SWITCH UNIT
Reset
Port Status
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
EXTender 7000
PWR and WAN
(Connected) Ports
1 2 AN PWR
WAN
Console Modem