McIntosh MX122, Руководство пользователя

Страница: 30 / 48

30
Audyssey
®
Auto Setup Procedure
With the MX122 connected to a TV/Monitor, the sup -
plied microphone connected to the SETUP MIC Jack
on the Rear Panel and placed in the "Main Listening
Location", perform the following steps along with the
instructions appearing On-Screen:
1. Press the AVP Push-button, then press the SETUP
Push-button.
2. Using the Remote Control Directional Push-but -
tons first select "Speakers" followed by "Audyssey
Setup". Refer to figure 19.
3. Select "Start", then press Enter.
4. Follow the instructions on the screen display and
press "Next" to proceed further.
5. When the following screen is displayed, select
"Begin Test" and then press Enter. Start the mea -
surement of the first position. Refer to figure 20.
6. A test tone will be sent to all channels, one at
a time to identify the channels making up your
system.
Notes: 1. Depending on the number of channels in
your system, the illustrations in this Owner's
Manual might differ from the actual On-
Screen Graphics.
2. During the setup process On-Screen error
messages may appear, if they do refer to page
32 for assistance.
7. When the detected speakers are displayed, select
"Next" and then press Enter. This will start the
Measurement Process. A special audio test signal
will be sent to all previously detected channels,
one at a time. Refer to figure 21.
Audyssey Setup will take measurements from eight
different locations in the room to achieve the best
possible sonic results. The additional measurement
locations are indicated by the small Balloons in the
room illustration, placed around the sitting area and
the Main sitting position is indicated by number "1".
8. Following the On-Screen instructions, place the
microphone in the 2nd listening position and then
press the ENTER Push-Button on the Remote
Control to select highlight on-screen button "Con -
tinue". Refer to figure 22.
9. Continue following the On-Screen instructions
and repeat the measurement process until all eight
listening positions have been measured. The On-
Screen message will now indicate the measure -
ments are finished. Refer to figure 23.
Note: Measurement of 3 listening positions are re-
quired to enable MultEQ® XT32.
10. Select "Continue", then press Enter.
11. Perform the settings for Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
.
Audyssey Setup
Channel Select
Amp Assign
Start
Your AV preamp can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone and microphone stand.
Set the following items
if necessary.
Figure 19
Begin Test Back
Select “Begin Test” to start the calibration.
NOTE: You will hear a series of loud chirps starting and stopping
during the tests.
Ear Height
Audyssey Setup
Figure 20
Audyssey Setup
Repeat Last Test Next
Speaker Detection
Front
Center
Subwoofer
Surround
Surr. Back
Front Wide
Front Height
:Yes
:Yes
:1 spkr
:Yes
:No
:No
:No
Figure 21
Complete Continue
Place the microphone ear level at the 2nd listening position,
which should be no more than 2 ft (60cm) away from the 1st
position, then select “Continue”...
Back
Ear Height
Audyssey Setup
Figure 22
Audyssey Setup
Continue
Repeat Last Test
Measurements complete.
Select Continue to analyze the data...
Figure 23