MECHANICAL
01-10–47
01-10
Connecting Rod Cap Assembly Note
Caution
•
When assembling the connecting rod caps, align the broken, rough faces of the connecting rods
and connecting rod caps.
•
If the following condition is met, replace the connecting rod cap bolts.
—
Length exceeds maximum
specification
Standard connecting rod cap bolt length
43.7—44.3 mm {1.73—1.74 in}
Maximum connecting rod cap bolt length
45.0 mm {1.77 in}
1. Position so that the broken, rough faces of the
connecting rods and connecting rod caps are
aligned exactly, and assemble the connecting rod
caps.
2. Tighten the connecting rod cap bolts in the
following two steps.
Tightening procedure
Step 1: 26—32 N·m {2.7—3.2 kgf·m, 20—23 ft·lbf}
Step 2: 80—100
°
Pilot Bearing Assembly Note
1. Install new pilot bearing to the specified position
using the following tools.
Tool
Snap-on brand millimeter size bushing
driver set (A160M) adapter A160M7 (20—
22 mm {0.79—0.86 in})
•
Use the adapter with the 20 mm {0.79 in}
side of the A160M7 (20—22 mm {0.79—
0.86 in}) facing the pilot bearing side.
Substitution tool
Outer diameter: 21 mm {0.83 in}
Inner diameter: 19 mm {0.75 in}
Standard pilot bearing position
Distance A of pilot bearing from crankshaft
end: 1.5—2.5 mm {0.060—0.098 in}
End Of Sie
L
adejjw00001214
bpe2ue00000046
PILOT BEARING
A
CRANKSHAFT
bpe2ue00000047
1A36-1U-12L.book 47 ページ ２０１２年１２月１０日 月曜日 午前９時２５分
