MECHANICAL
01-10–6
ENGINE MOUNTING/DISMOUNTING
id011000507000
Mounting
1. Install the
SST
(arms) to the three positions as shown in the figure and temporarily tighten the bolts (Part No.
9YA20-1003
or
M10
×
1.5 length 90 mm {3.55 in}
).
2. Install the
SSTs
(bolts and nuts) to the three
positions of the
SST
(plate) as shown in the
figure.
3. Install the
SST
(bolts, nuts and plate) set in Step 2
to the
SST
(arms) set in Step 1 using the
SSTs
(hook and nuts).
4. Adjust the bolts so that
approx. 20 mm {0.79 in}
of thread is exposed from the side of the plate.
5. Adjust the bolts and nuts so that the plate and
arms are parallel.
6. Tighten the
SSTs
(bolts and nuts) to affix the
SST
firmly.
7. Install the engine to the
SST
(engine stand).
8. Remove the oil drain plug and drain the engine
oil.
9. Replace the gasket with a new one and install the
oil pan drain plug.
Tightening torque
30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}
Dismounting
1. Dismount in the reverse order of mounting.
End Of Sie
SST INSTALLED
SST INSTALLATION HOLE
ENGINE FRONT
49 L010 102
bpe1ze00000084
49 L010 101
49 L010 104
49 L010 105
bp31je00000140
PARALLEL
ENGINE
APPROX. 20 mm {0.79 in}
49 L010 102
49 L010 104
49 L010 104
49 L010 103
49 L010 101
49 L010 105
bpe2ue00000089
1A36-1U-12L.book 6 ページ ２０１２年１２月１０日 月曜日 午前９時２５分
