maxon motor EPOS2 24/2, Справочник по аппаратуре

Страница: 34 / 48

Connections
Connectors
© 2017 maxon motor. Subject to change without prior notice.
maxon motor control
4-34
Document ID: rel7748 EPOS2 Positioning Controller
Edition: November 2017 EPOS2 24/2 Hardware Reference
4.2.9 Encoder Connector (J11)
Figure 4-34 Encoder Connector (J11)
The use of the connector depends on the type of DC motor (respectively its connecting cable) you are
using. Possible configurations are:
A maxon DC motor with separated motor/encoder cable
For further details  “Motor/Encoder Connector (J3)” on page 4-29.
B maxon DC motor with integrated motor/encoder ribbon cable
Proceed as follows:
Figure 4-35 Controller PCB – Solder Pads (JP701 & JP702
1) Find solder pads (  Figure 4-35, arrows) on controller PCB.
2) Bridge both solder pad pairs.
3) Connect motor/encoder ribbon cable to connector J11.
Note
With maxon DC motor with integrated motor/encoder ribbon cable , connector J10 will not be used!
For further details

page 4-29.
Accessories Cable Encoder Cable (275934)