connect chain to gate
2
YES
YES
6”
13.5”
13.5”
7.5”
7.5”
Concrete Pad
Idler Wheels
Idler Wheel
Chain
Bracket
Side Chain Guide
Side Chain Guide
IMPORTANT:
Operator and chain
MUST
be parallel to gate or the idler
wheels could fail. Use the “Fine Tune” adjustment on the gate bracket
connection bolt and make sure the chain runs through the idler wheels
without binding
on the side chain guides.
Minimum distance between the drive gear and gate is 4”.
Chain brackets
MUST
remain same height as
idler wheels.
Operator is too far from gate.
Chain is NOT parallel to gate.
Operator is too close to gate.
Chain is NOT parallel to gate.
Operator is NOT parallel to gate.
Chain is NOT parallel to gate.
DO NOT mount chain
bracket too high on gate.
NO
NO
YES
YES
YES
YES
Drive
Gear
NOTE:
The chain should
sag no more than one (1)
inch per 10 feet of travel.
Do not over tighten the
chain.
NOTE:
25 ft of #40 nickel plated chain included.
4” Min
4” Min
Top View of Operator
Back View of Operator
NO
NO
Gate Bracket
Fine Tune
Adjustment
4” Min
4” Min
NO
NO
NO
NO
NO
NO
Chain
Bracket
Chain
Bracket
Chain
Bracket
Chain
Bracket
DO NOT mount chain bracket too low on gate.
NO
NO
Factory installed
position
Note:
See manual when Connecting chain
with operator mounted in
REAR
Position.
Operator in Front Position (Standard)
IMPORTANT:
Physical stops
MUST
be
installed on
BOTH
ends of gate rail to
keep gate from traveling off of rail.
2
UL 325 2016 Standard-MAX Quick Install Rev 8
