MAXIDRY MAXI200, Руководство по установке

Страница: 33 / 78

113261 - 1 29
B. LOCATION REQUIREMENTS
Before installing the dryer, be sure the location conforms to local codes and ordinances. In the absence of such codes
or ordinances the location
must conform
with the National Fuel Gas Code ANSI.Z223.1 LATEST EDITION, or in
Canada, the installation
must conform
to applicable Canadian Standards: CAN/CGA-B149.1-M91 (Natural Gas) or
CAN/CGA-B149.2-M91 (Liquid Propane [L.P.] Gas) or LATEST EDITION (for General Installation and Gas
Plumbing).
The dryer requires 18-inches (45.72 cm) of space on each side of the dryer and 24-inches (60.96 cm) of space behind
the unit for ease of service. A minimum of 12-inches (30.48 cm)
must be
allowed between the top of a gas dryer and
the ceiling. A ceiling height of 120-inches (304.8 cm) is required for gas dryers, and a ceiling height of 130-inches
(330.2 cm) is required for steam dryers. The dryer
must be leveled for proper operation. If shimming is required, put
metal shims, which are the same size as the base feet under the base feet. The dryer must be lagged to the floor.
WARNING:
Dryer
should be
located where a minimum length of exhaust duct
will be
necessary.
1. The dryer
must be
installed with a proper exhaust duct connection to the outside.
2. The dryer must be installed with provisions for adequate combustion and make-up air supply.
CAUTION:
This dryer produces combustible lint and
must be
exhausted to the outdoors. Every 6
months, inspect the exhaust ducting and remove any lint build up.
IMPORTANT: Dryer must be installed in a location/environment, which the ambient
temperature remains between 40° F (4.44° C) and 130° F (54.44° C) .