MAXDATA Workstation Fusion 7000, Руководство пользователя

Страница: 33 / 46

33 MAXDATA Workstation Fusion 7000
5 Solving Problems
This chapter helps you identify and solve problems that might occur while you are using then system.
Resetting the System
To do this: Press:
Soft boot reset from DOS, which clears system memory and reloads the opera-
ting system. <Ctrl+Alt+Del>
Clear system memory, restart POST, and reload the operating system. Reset button
Cold boot reset. Turn the system power off and then on. This clears system
memory, restarts POST, reloads the operating system, and halts power to all
peripherals. Power off/on
Initial System Startup
Problems that occur at initial system startup are usually caused by incorrect installation or configuration.
Hardware failure is a less frequent cause.
Checklist
q
Is AC power available at the wall outlet?
q
Are the power supplies plugged in? Check the AC cable on the back of the chassis and at
the AC source.
q
Are all cables correctly connected and secured?
q
Are the processors fully seated in their sockets on the Workstation board?
q
Are all standoffs in the proper location and not touching any through hole components,
causing a potential short?
q
Are all add-in PCI boards fully seated in their slots on the Workstation board?
q
Are all jumper settings on the Workstation board correct?
q
Are all jumper and switch settings on add-in boards and peripheral devices correct?
To check these settings, refer to the manufacturer’s documentation that comes with them.
If applicable, ensure that there are no conflicts – for example, two add-in boards sharing
the same interrupt.
q
Are all peripheral devices installed correctly?
q If the system has a hard disk drive, is it properly formatted or configured?
q
Are all device drivers properly installed?
q
Are the configuration settings made in Setup correct?
q
Is the operating system properly loaded? Refer to the operating system documentation.
q
Did you press the system power on/off switch on the front panel to turn the Workstation
on (power on light should be lit)?
q
Is the system power cord properly connected to the system and plugged into a NEMA
5-15R outlet for 100-120 V~ or a NEMA 6-15R outlet for 200-240 V~?