MAXDATA Workstation Fusion 7000, Руководство пользователя

Страница: 31 / 46

31 MAXDATA Workstation Fusion 7000
4 Workstation Board Installations and Upgrades
Safety Cautions
System power on/off: The power button DOES NOT turn off the system AC power. To remove power
from system, you must unplug the AC power cord from the wall outlet. Make sure the AC power
cord is unplugged before you open the chassis, add, or remove any components.
Hazardous conditions, devices & cables: Hazardous electrical conditions may be present on power,
telephone, and communication cables. Turn off the Workstation and disconnect the power cord,
telecommunications systems, networks, and modems attached to the Workstation before opening
it. Otherwise, personal injury or equipment damage can result.
Electrostatic discharge (ESD) & ESD protection: ESD can damage disk drives, boards, and other parts.
We recommend that you perform all procedures in this chapter only at an ESD workstation. If one is
not available, provide some ESD protection by wearing an antistatic wrist strap attached to chassis
ground any unpainted metal surface on your Workstation when handling parts.
ESD and handling boards: Always handle boards carefully. They can be extremely sensitive to ESD.
Hold boards only by their edges. After removing a board from its protective wrapper or from the
Workstation, place the board component side up on a grounded, static free surface. Use a conductive
foam pad if available but not the board wrapper. Do not slide board over any surface.
Installing or removing jumpers: A jumper is a small plastic encased conductor that slips over two
jumper pins. Some jumpers have a small tab on top that you can grip with your fingertips or with a
pair of fine needle nosed pliers. If your jumpers do not have such a tab, take care when using needle
nosed pliers to remove or install a jumper; grip the narrow sides of the jumper with the pliers, never the
wide sides. Gripping the wide sides can damage the contacts inside the jumper, causing intermittent
problems with the function controlled by that jumper. Take care to grip with, but not squeeze, the pliers
or other tool you use to remove a jumper, or you may bend or break the stake pins on the board.
Safety and Regulatory Compliance
Intended uses: This product was evaluated for use in servers that will be installed in offices, computer
rooms, and similar locations. Other uses require further evaluation.
EMC testing: Before computer integration, make sure that the chassis, power supply, and other
modules have passed EMC testing using a Workstation board with a microprocessor from the same
family (or higher) and operating at the same (or higher) speed as the microprocessor used on this
Workstation board.
Workstation board diagram label provided: Place the label inside the chassis in an easy-to-see location,
preferably oriented similarly to the Workstation board.