Hi-T2
Centralised controller
16
Above, from left to right:
1)
STATUS SETUP;
2)
SET-POINT SETUP;
3)
PROGRAMS AND CHRONOTHERMOSTAT.
At the bottom, from left to right:
4)
SPECIAL FUNCTIONS;
5)
CONFIGURATION;
6)
HELP MENU.
3.6.1
STATUS SETUP PAGE
Press the button to enter the “Status setup” page.
Figure 17. “Status setup” page.
Pressing “System”, you can set the status of the entire system, otherwise you can act on the individual units.
3.6.2
SET-POINT SETUP PAGE
Press the button to enter the “Set-point setup” page.
Figure 18. “Set-point setup” page.
From this screen you can set the parameters of the chiller and of the configured fan coil zones. If enabled, you can also set the
domestic hot water setpoint (see Paragraph 4.6.2) and for rapid DHW preparator, the second set-point (see Paragraph 4.9) and the
offset for climatic compensation (see Paragraph 4.10).
3.6.3
PROGRAMS PAGE (CHRONOTHERMOSTAT)
Press the button to enter the “Programs” page.
STATUS SETUP
Chiller
Zone 1
Zone 2
Zone 3
eco
System
SET-POINT SETUP
Chiller
Zone 1
